A06B-6117-H302 FANUC SERVO AMP MODULE AISV-10/10/10
Part Name: FANUC SERVO AMP MODULE AISV-10/10/10
Part Number: A06B-6117-H302
A06B-6117-H302 FANUC Servo Amp Module AISV-10/10/10
The A06B-6117-H302 FANUC Servo Amp Module AISV-10/10/10 gives power to the servo motor of CNC machines. Tri Star's repair technicians are educated and experienced in the restoration and repair of CNC machine parts like the A06B-6117-H302 FANUC Servo Amp Module AISV-10/10/10. When they cannot repair your machine, Tri Star offers replacements on an exchange basis.
When our technicians receive your CNC machine, they will do a thorough inspection for damaged components. If no repairs are required, they will simply bill you for the inspection and a cleaning of your CNC machine. If repairs do need to be made, our technicians will use their expertise to make the highest quality repairs and then will replace smaller components of your machine to make sure it will continue to run properly longer. Check your machine regularly and send it in for repairs immediately when needed to avoid more costly charges.
Alarm & error codes
Tri Star CNC Services can provide you with more information on the meaning of your alarms. We will provide a fault diagnosis and a dependable 1-year warranty if you require FANUC servo repairs - or a new FANUC servo amplifier module or FANUC DC servo unit. Give us a call - phone support is FREE and we'll clearly define your options for parts repair or replacement:
|0||Unit is ready.|
|- (dash)||Unit is not ready and could be related to the unit or machine side cause.|
|Blinking "-"||(a) Disconnect the feedback cable (JF*) from the Servo Amplifier, and then switch on the power.
<1> If blinking continues → Replace the Servo Amplifier.
<2> If blinking stops → Go to (b).
(b) Disconnect the feedback cable (JF*) from the Pulsecoder, and then switch on the power. (Keep
the cable on the Servo Amplifier side connected.)
<1> If blinking continues → Replace the cable.
<2> If blinking stops → Replace the motor.
|1||DC voltage of the main circuit power supply is abnormally high.|
|2||Inverter: control power supply undervoltage.|
|5||Average regenerative discharge energy is too high (too frequent acceleration/deceleration)–The transformer overheats.|
|8||Abnormal current alarm (L axis)|
|8. (dot)||Inverter: IPM (L axis)|
|9||Abnormal current alarm (M axis)|
|9. (dot)||Inverter: IPM alarm (M axis)|
|A||Abnormal current alarm (N axis)|
|A. (dot)||Inverter: IPM alarm (N axis)|
|b||Abnormally high current in the L–and M–axis motors|
|c||DC link current alarm (M axis)|
|d||DC link current alarm N axis)|
|F||External cooling circuit faulty|
|L||FSSB communication error|
|P||Communication error between amplifier and module|
|U||FSSB communication error|