A06B-6140-H037 FANUC POWER SUPPLY MODULE AIPS-37
Part Name: FANUC POWER SUPPLY MODULE AIPS-37
Part Number: A06B-6140-H037
FANUC POWER SUPPLY MODULE AIPS-37 A06B-6140-H037
The A06B-6140-H037 power supply module is an APHA I AiPS-37 unit in the A06B-6140 product series. A failing power supply due to overcurrent, circuit failure, faulty RAM/ROM or overheating discharge units causes myriad problems in your CNC machinery.
Fill out an Return Material Authorization (RMA) for repairs.
All work is done in-house at our facility in McHenry, Illinois. We meticulously test the A06B-6140-H037 FANUC power supply on a closed loop to diagnose and repair the issue. We'll also replace any electrical components with a high rate of failure for no extra charge.
FANUC Power Supply Alarm Codes
Is your A06B-6140-H037 power supply module throwing an error? Check our list of FANUC power supply alarm codes or call us for a solution.
Contact Tri Star CNC Services for repairs or a replacement A06B-6140-H037 power supply module.
Alarm & error codes
Tri Star CNC Services can provide you with more information on the meaning of your alarms. We will provide a fault diagnosis and a dependable 1-year warranty if you require FANUC power supply repairs - or a new FANUC power supply module. Give us a call - phone support is FREE and we'll clearly define your options for parts repair or replacement:
|0||Unit is ready|
|-(dash)||Unit is not ready and could be related to the unit or a machine side cause.|
|1||PSM-5.5 to PSM-11||The main circuit power module (IPM) has detected an overload, over-current, or control supply voltage decrease, over-current, or control supply voltage decrease. Internal cooling circuit failure, Overload, Input supply voltage imbalance, IPM failure, or control supply voltage decrease of the power module.|
|1||PSM-15 to PSM-55||Over-current flowed into the input of the main circuit. Input supply voltage imbalance, IGBT defective.|
|2||Internal cooling circuit faulty.|
|3||The temperature of the heat sink has risen.|
|4||DC voltage (DC link) has dropped|
|5||The input power supply is abnormal (open phase) or the main circuit capacitor was not recharged within the specified time.|
|6||The input power supply is abnormal (open phase).|
|7||The DC link voltage is abnormally high.|
|8||The offset of the current detection circuit of the main circuit DC link is excessive.|
|8||PSMR||The regenerative discharge unit is heated.|
|A||Internal cooling circuit faulty.|
|E||The input power supply is abnormal (open phase).|
|H||PSMR||The temperature of the regenerative resistor has arisen abnormally|