A06B-6110-H037 FANUC POWER SUPPLY MODULE PSM-37I
Part Name: FANUC POWER SUPPLY MODULE PSM-37I
Part Number: A06B-6110-H037
A06B-6110-H037 PSM-37I FANUC Power Supply Module Drive
The A06B-6110-H037 PSM-37I is one of the largest FANUC alpha power supply modules powering mid-sized to large spindle and servo amplifier drives.
FANUC Power Supply Alarm Codes
Is your A06B-6110-H037 power supply throwing an error? Check our list of FANUC power supply alarm codes or call us for a solution.
The A06B-6110-H037 PSM-37I is the most recent power supply module configured for 200v, three phase alpha power amplifiers in large CNC machining centers.
Fill out an Return Material Authorization (RMA) for repairs.
When your A06B-6110-H037 PSM-37I requires CNC machine repair or FANUC replacement part, call the FANUC repair service specialists at Tri Star CNC Services, LLC.
Alarm & error codes
Tri Star CNC Services can provide you with more information on the meaning of your alarms. We will provide a fault diagnosis and a dependable 1-year warranty if you require FANUC power supply repairs - or a new FANUC power supply module. Give us a call - phone support is FREE and we'll clearly define your options for parts repair or replacement:
|0||Unit is ready|
|-(dash)||Unit is not ready and could be related to the unit or a machine side cause.|
|1||PSM-5.5 to PSM-11||The main circuit power module (IPM) has detected an overload, over-current, or control supply voltage decrease, over-current, or control supply voltage decrease. Internal cooling circuit failure, Overload, Input supply voltage imbalance, IPM failure, or control supply voltage decrease of the power module.|
|1||PSM-15 to PSM-55||Over-current flowed into the input of the main circuit. Input supply voltage imbalance, IGBT defective.|
|2||Internal cooling circuit faulty.|
|3||The temperature of the heat sink has risen.|
|4||DC voltage (DC link) has dropped|
|5||The input power supply is abnormal (open phase) or the main circuit capacitor was not recharged within the specified time.|
|6||The input power supply is abnormal (open phase).|
|7||The DC link voltage is abnormally high.|
|8||The offset of the current detection circuit of the main circuit DC link is excessive.|
|8||PSMR||The regenerative discharge unit is heated.|
|A||Internal cooling circuit faulty.|
|E||The input power supply is abnormal (open phase).|
|H||PSMR||The temperature of the regenerative resistor has arisen abnormally|